Army Legacy graphic kit for Beta RR 50 from 2011. New graphics and new colors to make you stand out during walks or gatherings. Our Army decoration kits are printed in high definition and covered with a protective film. This Army sticker set comes with the adhesives for supermotard or enduro rim laps.
Why choose an Army Legacy graphics kit?
- wash-resistant graphics kit
- UV protection
- High opacity vinyl
- Long lasting
- Strong glue< /span>
- Easy to install thanks to the cut-outs
How to apply the decal kit on Beta RR 50:
- Clean the Beta RR fairing to remove all traces of grease.
- Spray the fairing lightly with soapy water.
- Heat the sticker using a hair dryer.
- Apply and position the sticker. (easy to adjust with water).
- Let the sticker on the Beta RR fairing dry.
Here are the steps to follow to install a 50cc motorcycle graphic kit:
Preparation : Make sure you have all the necessary materials, including the decoration kit, a spatula, spray cleaner, a cutter or razor blade, and a hair dryer.
Cleaning : Thoroughly clean the areas where you want to install the decoration kit. Be sure to remove all dirt, dust, grease, etc.
Cutting : If necessary, use a razor blade or craft knife to trim the edges.
Apply the first piece: Slowly peel the backing from the first piece of the graphic kit and carefully place it on the fairing. Use a spatula to remove air bubbles and to firmly apply the vinyl.
Apply the other pieces: Continue to apply the other pieces of the decorative kit following the same steps as before. Make sure you align them correctly and place them carefully to avoid air bubbles.
Drying: Use a hair dryer to dry the vinyl and to ensure optimal adhesion.
Finishing : Once all the pieces are in place, check that the deco kit is installed correctly. If necessary, use a craft knife or razor blade to trim the edges.
Note that every deco kit is different, so there may be variations in the steps mentioned above. Be sure to follow the instructions included with the deco kit for successful installation.
The manufacture of a motorcycle decoration kit includes several stages:
Validation of the customer model - The customer validates the design and colors of the decorative kit.
Printed on high quality vinyl - The design is printed on high quality vinyl to ensure excellent weather resistance and long-term durability.
Drying - The printed vinyl is left to dry to ensure good adhesion.
Hot lamination of a protective film - The printed vinyl is covered with a 450 micron protective film to protect the print from scratches and weather damage.
Precise cuts - The cut-out shapes are precise thanks to improved tools for a perfect fit on the motorcycle.
Quality control - A quality inspection is carried out to ensure that the deco kit meets customer specifications and is free from defects.
Sending to customer - The decorative kit is sent to the customer with tracking and SMS notifications.