Contact Us

Before starting, prepare the following items:

• A clean, lint-free cloth
  
• A degreasing cleaner (such as isopropyl alcohol, IPA 70% or 90%)
  
• A soft squeegee or a plastic card wrapped in microfiber
  
• A hairdryer or a heat gun (on low power)
  
• Your stickers sorted by parts (fairing, fender, sides, etc.)
  

Make sure to work in a clean, dry, and dust-free area.

Perfect preparation ensures optimal adhesion.

• Carefully wash the motorcycle to remove dirt.
  
• Dry all the fairings.
  
• Degrease all surfaces where the decal kit will be applied with isopropyl alcohol.
  
• Pay particular attention to:
  the flanks,
  the air box,
  the front and rear fenders,
  the side covers,
  the tank (if applicable).
  

No trace of grease, dust, or silicone should remain on the plastics.

Before sticking permanently:

• Place each sticker in front of its location.
  
• Check the orientation, markers, and curves.
  
• Visually adjust the overall position.
  

A dry fit allows you to avoid mistakes once the adhesive is applied.

The steps below ensure a clean, bubble-free, and durable installation.

4.1 Peeling and positioning

• Peel off a small part of the liner (the white paper on the back).
  
• Position the sticker on the fairing part.
  
• First stick one end (usually the center or the straightest edge).
  

Do not stick all at once: work progressively.

4.2 Progressive sticking and squeegee

• Proceed little by little, removing the liner as you go.
  
• Use a squeegee or a card wrapped in a cloth to smooth the surface.
  
• Push the air out from the center towards the edges.
  
• If a bubble appears, peel off slightly then stick back on.
  

Thanks to the FLO anti-bubble adhesive, air escapes easily.

4.3 Light heating

Applying heat softens the vinyl and allows it to perfectly conform to shapes.

• Heat slightly with a hairdryer (never too hot).
  
• Apply extra pressure in curved areas.
  
• Do not overheat: an excessively heated vinyl becomes too soft and deforms.

After sticking all the elements:

• Check every edge and angle.
  
• Heat very slightly to activate the glue and improve adhesion.
  
• Press firmly on sensitive areas: ends, curves, angles.
  

Let the motorcycle rest for at least 24 hours before washing or strong sun exposure.

• Never install a decal kit on a cold or damp surface.
  
• Do not use silicone products before installation.
  
• Avoid water during installation (dry method recommended for FLO premium vinyls).
  
• The cleaner the surface, the longer the adhesion will last.
  
• In case of error, peel off immediately and reposition; premium vinyl allows this.
  

Maintenance of your decal kit

To extend the vinyl's lifespan:

• Wash the motorcycle by hand (avoid high-pressure washers too close).
  
• Use gentle products, without harsh solvents.
  
• For glittery or holographic finishes, prefer manual washing only.
  

Careful maintenance ensures your decal kit stays vibrant for years.

Need help or advice?

Our team is available to assist you with installing your decal kit.

Whether it's for an adjustment, a surface issue, or a question about installation, we respond quickly.