Graphics kit Stark Varg Future 2021-2026 Send It

The Graphics-kit Send It for the Stark Varg is dedicated to riders who turn every bump into a launch ramp. The Varg is an electric motocross bike with devastating power; with this graphics-kit featuring an aggressive and rebellious look, your machine makes a statement right from the starting gate and takes on the appearance of a true freestyle beast.

A radical and explosive Stark Varg design for your electric MX

The Send It design rejects caution. It is built around sharp contrasts, bold lettering inspired by street culture, and strong lines that amplify the bike’s natural dynamism. This is the ultimate Stark Varg design for riders seeking an "FMX / Adrenaline" style, fully embracing the raw power and edge of this extraordinary motorization.

• Send It Unlimited Design: An "Action Sports" aesthetic dominated by saturated neon tones and striking graphics. A rebellious style that instantly gives the Stark Varg a fierce character.
• Adjusted Stark Varg Templates (21-26): Perfect execution requires precise preparation. Our templates fit with deadly accuracy the minimalist bodywork, battery cover, and front plate of your motocross, allowing your Stark Varg design to display its patterns without a single wrinkle.
• "Armor Tech" 450 Micron UV-Resistant Vinyl: Designed to survive the harshest landings. Our motocross-quality vinyl withstands impacts, boot scuffs, and mud. The intensity of your neon colors is protected by a powerful UV filter to brave the sun on the track.
• Easy Bubble-Free Application: A professional bike finish, applied without any hassle. The honeycomb adhesive technology instantly evacuates air under the squeegee. The result is clean, perfectly taut, and guaranteed 100% bubble-free.

Complete graphics-kit contents for Stark Varg:

The full extreme gear for your electric motocross:

• Front plate and fork guards (The attack signal)
• Front and rear fenders
• Side vents and battery cover (The heart of the explosion)
• Rear side plates and swingarm

Recommended finishes

To make the "Freestyle" side of the Send It design pop, the Glossy finish is a must: it gives that "New Plastic / Factory Bike" effect that will highlight the aggressive colors with every jump. The Holographic finish is also amazing for this design, adding rainbow reflections that flash under the sun during your whips. Finally, the Matte finish brings a darker "Rubber / Streetwear" vibe that is just as fierce by absorbing light.

Follow these 4 simple steps to install your holographic decoration kit on your 50cc motorcycle decoration kit and achieve a professional finish:

1. Surface Preparation:

   Carefully clean the application area of your 50cc with a mild degreaser to remove dust, dirt, and oil residues. A clean surface is essential for your holographic decor kit to adhere properly.

2. Measurement and Marking:

   Measure precisely the area to be decorated on your 50cc motorcycle decoration kit. Use a non-permanent pencil to lightly mark the outlines and facilitate the alignment of the vinyl during installation.

3. Vinyl/Sticker Application:

   Partially peel off the backing of the vinyl or sticker. Carefully position it on the marked area, then gradually remove the backing while smoothing the material with a squeegee or microfiber cloth to eliminate air bubbles and ensure perfect adhesion.

4. Finishes and Verification:

   Check that the vinyl is well secured over the entire surface of your 50cc motorcycle decoration kit. Remove the protective film and make any necessary touch-ups to highlight the unique effect of your holographic decoration kit.